Overview

The Garmin 010-13248-02 is a 0-degree pole mount for positioning a LiveScope XR LVS62 transducer on a pole with a fixed viewing angle.

It is commonly used for ice fishing and it also works for open water fishing when you want to deploy the transducer from a pole and move it as conditions change.

Key features

• Made for the Garmin LiveScope XR LVS62 transducer
• 0-degree pole-mount angle to hold the transducer in a consistent orientation
• Works for ice fishing setups and open-water pole deployments
• Helpful when you want to scan from a pole without committing the LVS62 to a permanent mounting location

Compatibility and fit

This mount is intended for the LiveScope XR LVS62 transducer. Confirm the transducer model on your system before ordering so the mounting points match.

Installation and setup

Mount the bracket to your pole, secure the LVS62 to the mount, then align the transducer so the live sonar view makes sense for how you fish. Take a minute to set cable routing so it stays clear of pinch points, sharp edges, and anything that can chafe when the pole rotates or stows.

On a boat, a pole mount is often used at the bow or over the side to scan structure without putting the transducer on the trolling motor. For ice fishing, it helps keep the transducer controlled through the hole so you can point and hold your view where you want it.

Use cases on board

This is a good match for anglers running LiveScope XR who prefer a pole-deployed transducer for ice season and for open-water scanning when you want to move the LVS62 around the boat.

Maintenance and care

After use, rinse the mount if it has been exposed to saltwater spray, then check fasteners for looseness from vibration and trailering. Store it dry to keep hardware from corroding and to avoid salt buildup around moving interfaces.