Overview

The Garmin 010-12505-00 is a trim ring snap cover for Garmin VHF 210 and VHF 215 marine radios. It snaps onto the radio face to replace a cover that has gone missing or cracked, bringing the bezel back to a finished look at the helm.

Fit is specific to the VHF 210, VHF 215, and their AIS versions, so it is a straightforward way to tidy up a dash installation without touching wiring, power, or radio settings.

Key features

• Replacement trim ring snap cover for Garmin VHF 210 and VHF 215 fixed-mount radios
• Also fits the VHF 210 AIS and VHF 215 AIS versions
• Snap-on part with no electrical connections required
• Restores the finished appearance of the radio face when the original cover is lost or damaged
• Quick swap during routine maintenance or a refit without pulling the radio from the system

Compatibility and fit

Confirm the radio model at your helm before ordering. This cover is made for the VHF 210 and VHF 215 family, including the AIS variants, and it is not intended as a universal cover for other VHF models.

Installation and setup

Clean the radio face and remove any remaining broken pieces from the original trim cover. Align the snap cover with the trim ring area on the front of the radio, then press evenly until it seats fully around the edges.

Use on board

This part makes sense for boats that keep the radio exposed at the helm, where small trim pieces can get bumped during docking, cleaning, or regular cockpit traffic. It is also useful for refits where you want the radio to look complete again without changing the radio installation.

Maintenance and care

Rinse with fresh water after salt spray and wipe with a soft cloth. Avoid harsh solvents that can dull plastics and finishes on helm electronics.