OverviewThe Vimar Arké 19209 P30 socket outlet is a 2-module Italian-standard socket for flush-mounted AC installations, rated at 16A, 250V, and 50/60 Hz. It uses the P30 format with lateral and...

OverviewThe Vimar Arké SICURY P11 socket outlet is a 2P+E outlet for Italian standard P11 plugs with a 1-module format, flush mounting, and a 10 A 250 V rating. It uses screw terminals, supports 50...

OverviewThe Vimar Arké 19008 is a 1-pole normally-open push button rated 10 A at 250 V AC for Arké modular frames and cover plates.It works as a momentary control: the contact closes only while the...

OverviewThe Vimar Arké 19340 is a MINI-COM Panduit adaptor for the ARKÉ device range, used to mount a compatible Panduit MINI-COM connector in a finished panel position. It measures 22.2 mm wide, 49...

OverviewThe Vimar Arké HDMI 2.1b outlet is a 1-module flush-mounted insert for bringing an HDMI connection to a finished panel or wall point on board. It uses Keystone fixing, carries an IP20 rating,...

OverviewThe Vimar Arké 19147 is a flush-mounted rotary dimmer for 120 V AC lighting circuits. It runs at 50-60 Hz and is rated for 30-500 W incandescent loads or 30-300 VA circuits using...

OverviewThe Vimar Arké 19654 is a 4-module cover plate used to finish a Vimar Arké switch, socket, or control group on board.It attaches with clamp fastening to a 4-module Arké support and can be...

OverviewThe Vimar Arké 19652 is a 2-central-module cover plate used to finish a two-module Arké switch or outlet position with a clean, flush-looking front. The plate face measures 122 x 90 mm, and...

OverviewThe Vimar Arké 19041 is a 1-module blank module for the ARKÉ flush-mounted wiring range. It closes an unused module position so the face of the installation stays finished while leaving room...

OverviewThis Vimar LED signalling unit is an indicator insert for compatible switch and push-button assemblies where you need a clear status light on an onboard panel. Across this range, the...

OverviewThis Vimar LED signalling unit is a low-voltage insert for compatible rocker switches and push buttons, with a 12-24 V AC/DC input and a 0.1 W draw. It works as a built-in indicator or...

OverviewThe Vimar VM14903 is a 3-module surface enclosure that gives Vimar Eikon, Arké, and Plana devices a protected mounting point in areas that see spray, washdowns, or general exposure on board...