Attwood Marine Ski Tow Ring, 304 Stainless Steel, 2-1/2 in

Overview

The Attwood Marine 66450-5 is a 2-1/2 inch ring-style stainless ski tow for PWCs, I/Os, and inboard ski boats. It is built in 304 stainless steel with smoothed welded seams and a polished finish, and the wide welded-on ring base meets the hull without needing an exterior mounting plate. Stainless mounting washers and nuts are included, and the tow exceeds American Water Ski Association standards.

This style works as a fixed transom tow point when you want a straightforward setup for skiing and other tow-line use on smaller boats. The 2-1/2 inch ring keeps the hardware compact, while the polished surface and smooth welds help keep the attachment point clean and easy to use.

Key features

• 2-1/2 inch ring-style ski tow for PWCs, I/Os, and inboard ski boats
• 304 stainless steel construction with smoothed welded seams and a polished finish
• Wide welded-on mounting ring sits against the hull, so no exterior mounting plate is needed
• Stainless mounting washers and nuts are included for installation
• Exceeds American Water Ski Association standards

Installation and fit

This tow mounts through the transom and needs interior access to secure the included washers and nuts. It suits installations where the mounting area is flat enough for the ring base to seat cleanly against the hull and where you want a visible ring tow rather than a flush-mount hook.

Use on board

This is a good match for boat owners adding or replacing a ring-style tow point on a PWC, ski boat, or smaller runabout set up for watersports. On boats used in saltwater, routine freshwater rinse-down helps keep the polished stainless looking better over time.