TACO Marine Rod Holder Liner with Lip Protection, For F31-2200, F31-2230, F31-2240, Anti-Fungal PVC

Overview

The TACO Marine 2200 series Rod Holder Liner is a replacement liner with lip protection for TACO F31-22 Series flared aluminum rod holders. It fits the F31-2200, F31-2230, and F31-2240 rod holders, which are sold separately, and helps protect reels from contact damage while also shielding powder-coated holder edges from chips.

Made from anti-fungal PVC, this liner is shaped for flared-style aluminum rod holders and measures 8-5/8" long with a 2-1/2" outside diameter and 1.63" inside diameter. It is a small but useful service part for fishing boats, towers, leaning posts, and rod storage locations where rods are moved in and out often during a day on the water.

Key features

• Fits TACO F31-2200, F31-2230, and F31-2240 flared aluminum rod holders.
• Made from anti-fungal PVC for use in wet marine rod holder locations.
• Lip protection helps reduce chipping on powder-coated rod holder edges.
• Helps protect reels from damage where gear contacts the top of the holder.
• Measures 8-5/8" long with a 2-1/2" outside diameter and 1.63" inside diameter.
• Offered in white or black to match the look of the rod holder and surrounding hardware.
• Covered by a 3-year limited warranty.

Variants

This rod holder liner is offered in two color configurations for the same F31-22 Series application.

The color is the visible difference between the variants. The length, outside diameter, inside diameter, rod holder series, material, and compatible TACO rod holder models remain the same across both options.

• F31-2202WHA-C: White. This finish works well where the liner needs to blend with white powder-coated hardware, fiberglass areas, or light-colored cockpit and tower details.
• F31-2202BKA-C: Black. This finish gives the liner a darker look for black rod holders, black trim, or hardware layouts where contrast is preferred.

Compatibility and fit

This liner is for TACO 2200 series flared-style aluminum rod holders in the F31-22 Series. It should be matched to the holder model before ordering, especially when replacing an older liner on a tower, leaning post, rocket launcher, or custom fishing station.

Installation and use

The liner installs inside the rod holder opening and adds a protective lip at the top edge, where rods and reels see frequent contact. It is a practical replacement part for boats used for fishing, coastal cruising with rod storage, or any setup where powder-coated rod holders need extra edge protection during regular use.

Maintenance and care

Rinse the liner with fresh water after saltwater trips and clear away sand, scales, and dried salt from the lip area. Keeping the liner clean helps rods slide in and out smoothly and reduces abrasive buildup around the holder edge.