Raymarine Power Cable, For Dragonfly 5M, 1.5m

Overview

The Raymarine R70376 is a 1.5 m power cable for the Raymarine Dragonfly 5M display. It is made for the Dragonfly 5M only, so it should be matched to that exact unit before ordering.

This cable is a practical replacement or spare lead for small-boat electronics installations where the display is mounted at the helm, console, or dash and the power source is close enough for a short 1.5 m run. It is especially useful when a boat is being refit, a display is being moved, or the original cable has been misplaced or damaged.

Key features

• 1.5 m cable length for short power runs at the helm, console, or electronics panel.
• Made for the Raymarine Dragonfly 5M display only.
• Useful as a replacement power lead when the original cable is missing, worn, or damaged.
• Helps keep the installation tidy when the power connection is close to the display location.
• Raymarine accessory cable matched to the Dragonfly 5M power connection.

Compatibility and fit

This cable should be used only with the Raymarine Dragonfly 5M. It is not a universal Dragonfly cable, and it should not be selected for other Raymarine displays unless the vessel already has a confirmed Dragonfly 5M installation that uses this specific cable.

Installation and setup

Before installation, check the route from the Dragonfly 5M mounting position to the vessel power connection and confirm that 1.5 m provides enough reach without pulling, tight bends, or strain at the connector. Leave a service loop where possible so the display can be removed or inspected without stressing the cable.

Route the cable away from sharp edges, hot engine-room surfaces, and areas where gear or passengers may rub against it. In open helm or console spaces, secure the run so vibration and repeated movement do not work the connection loose over time.

Use cases on board

This cable is a good match for owners maintaining a Dragonfly 5M on a center console, small cruiser, fishing boat, or tender where the display is mounted close to the electrical panel or a dedicated accessory circuit. It is also useful for replacing a cable during an electronics refresh without changing the display itself.