Garmin Force Trolling Motor Propeller Mounting Hardware Kit

Overview

The Garmin S00-01000-64 is replacement prop mounting hardware for Garmin Force trolling motors. It covers the small parts that secure the propeller on the lower unit when the original hardware is worn, corroded, or misplaced during a prop swap.

This is hardware only, so it is meant for situations where the prop itself is still serviceable but the fasteners and related pieces need to be refreshed. It is a practical spare to keep onboard if you regularly pull the prop for weed and fishing line cleanout, seasonal service, or after a minor strike.

Key features

• Replacement prop mounting hardware for Garmin Force trolling motors
• Useful when prop hardware is missing, damaged, or showing corrosion after use
• Supports correct prop reinstallation after cleaning line or debris from the shaft area
• Small spare parts that are easy to stow in a boat tool kit for on-water fixes

Compatibility and fit

Intended for Garmin Force trolling motors. Before ordering, compare the hardware arrangement on your motor to confirm you are matching what you are replacing.

Installation and setup

Disconnect trolling motor power at the batteries before working around the propeller. Remove the propeller, clean the prop shaft area, and install the new hardware in the same order as the original parts. After reassembly, spin the prop by hand to confirm it turns freely and sits correctly.

If the prop was removed due to an impact, take a moment to inspect the prop and the prop area for damage before putting the motor back into service.

Maintenance and care

On saltwater boats, a quick rinse of the lower unit after use helps slow corrosion around prop hardware. During routine service, remove any fishing line and reassemble with all hardware seated fully so the prop stays secure in use.