TACO Marine Flexible Vinyl Rub Rail Insert, For Rigid and Aluminum Rub Rail, 1 in x 1/2 in, Soft PVC

Overview

The TACO Marine V12-0303 is a flexible vinyl rub rail insert for boats that use a 1 in x 1/2 in insert profile. It fits into the rub rail channel to cover fasteners, clean up the hull-to-deck joint, and add a cushioning surface along the rub rail where the boat meets docks, pilings, and other contact points.

This insert is offered in continuous lengths from 50 ft to 300 ft, which helps reduce visible seams during replacement work. The range includes Black, Arctic White, and Frosty White options, so the insert can match or contrast with the existing rub rail and hull finish.

Key features

• Flexible vinyl insert with a 1 in height and 1/2 in width profile for compatible TACO Marine rub rail channels.
• Covers exposed rub rail fasteners for a cleaner finished edge around the boat.
• Available in continuous coil lengths, including 50 ft, 70 ft, and 300 ft configurations, to help reduce seams during installation.
• Color options include Black, Arctic White, and Frosty White for matching common hull and rub rail finishes.
• Soft vinyl construction adds a cushion at the rub rail contact surface during normal docking and close-quarters handling.

Variants

The V12-0303 range varies by length and color. Length options include 50 ft, 70 ft, and 300 ft, while color options include Black, Arctic White, and Frosty White.

All listed configurations share the same 1 in x 1/2 in insert profile, so the main buying decision is matching the required run length and exterior color to the boat’s existing rub rail setup.

Installation and fit

Check the existing rub rail channel before ordering and confirm that it accepts a 1 in x 1/2 in flexible insert. This is especially important when replacing older rub rail trim, since similar-looking inserts can vary enough in shape or height to affect fit.

During installation, warming a short section of the insert can make it easier to work into the rub rail channel. Work in manageable sections and seat the insert evenly so it follows the sheer line without pulling, twisting, or leaving gaps around curves.

Use on board

This insert suits replacement work on runabouts, center consoles, fishing boats, cruisers, and other boats with compatible rub rail profiles. It is most useful when the existing insert is cracked, faded, missing sections, or no longer covering the fasteners cleanly.

For a clean result, measure the full rub rail run before selecting a length and allow for trimming at the ends. A longer continuous length can help create a more finished look on boats where a seam-free installation is preferred.

Maintenance and care

Rinse the insert with fresh water after saltwater use and clean it with mild boat soap when dirt or dock residue builds up. Avoid harsh solvents that can affect vinyl surfaces or leave uneven discoloration over time.