TACO Marine Stainless Steel Solid Back Rub Rail, 1 in x 20 ft, 316, Polished

Overview

The TACO Marine S11-465SP20B is a 1 in stainless steel solid-back rub rail supplied in a 20 ft length for protecting the hull-to-deck edge, sheer line, or other exposed areas that take contact at the dock. Its polished 316 stainless steel profile gives larger boats and yachts a clean finished edge while adding a hard wearing surface where fiberglass, gelcoat, or vinyl rail systems need extra protection.

This rail measures 1 in high by 1/4 in wide and is drilled and countersunk on 6 in centers for #12 fasteners. It can be used as a stainless steel overlay with compatible rub rail profiles or installed on its own where a narrow chafe or bumper strip is needed along the boat.

Key features

• Solid-back stainless steel rub rail for areas that need a firm protective edge rather than a flexible insert.
• 316 stainless steel construction suits exposed marine use where salt spray, dock contact, and regular washdowns are part of the boat’s routine.
• Polished finish gives the rail a clean bright appearance that fits well on larger boats and yachts.
• 20 ft length helps cover long runs with fewer joints compared with shorter rail sections.
• 1 in height and 1/4 in width make it a narrow protective profile for hull sides, cap rails, transoms, or compatible rub rail assemblies.
• Drilled and countersunk on 6 in centers for #12 screws, which helps keep spacing consistent during installation.
• Can be used as an overlay with certain rub rail profiles or as a standalone chafe strip where the mounting surface supports it.

Installation and fit

Before ordering, compare the 1 in by 1/4 in profile against the existing rail or the area being protected. This part is a solid-back stainless rail, so the mounting surface should be fair enough to support the rail evenly along the run. On curved sections, careful dry fitting is important before drilling or final fastening.

The pre-drilled countersunk holes are laid out on 6 in centers for #12 screws. Fasteners are selected separately, so they should match the boat’s substrate, backing, and corrosion requirements. Bedding compound may be needed where fasteners pass into fiberglass or cored structures to help protect the laminate from water intrusion.

Use cases on board

This rub rail is a practical match for refits where the existing edge protection is worn, dented, or no longer gives the boat a finished look. It also works well on high-contact areas around docking zones, swim platforms, transom edges, and other spots where a polished stainless strip can take everyday scuffs better than exposed gelcoat.

Care and maintenance

Rinse the rail with fresh water after saltwater use and clean it with products suitable for stainless steel. Regular care helps preserve the polished surface, especially around screw heads and seams where salt can collect.