TACO Marine Stainless Steel Solid Back Rub Rail, 316L, 1-1/4 in, 20 ft, #12 Screws, 6 in Centers

Overview

The TACO Marine S11-467SP20B is a 1-1/4 inch solid-back stainless steel rub rail supplied in a 20 foot length for protecting the hull-to-deck edge, sheerline, or other exposed areas that take contact from docks, pilings, fenders, and neighboring boats.

This rail uses Type 316 stainless steel with a polished finish, making it a strong fit for saltwater boats where appearance and corrosion resistance both matter. The profile is 1-1/4 inch wide and 1/4 inch thick, with pre-drilled and countersunk holes for #12 screws on 6 inch centers.

Its solid-back profile gives the rail a clean, finished look and helps spread impact along the mounting surface. It can be used as a stand-alone stainless rub rail or as part of a rub rail repair where the boat’s existing profile and fastening layout match.

Key features

• 1-1/4 inch wide solid-back stainless steel rub rail for hull edge and sheerline protection.
• Type 316 stainless steel suits saltwater use where corrosion resistance is a key buying factor.
• Polished finish gives the rub rail a clean visual match for many production and custom boats.
• 20 foot length supports long, continuous runs with fewer joints along the hull side.
• Pre-drilled and countersunk for #12 screws on 6 inch centers to simplify alignment during installation.
• 1/4 inch thickness adds a substantial wear surface for contact with docks, pilings, and fenders.

Installation and fit

Before ordering, match the 1-1/4 inch width, 1/4 inch thickness, and hole pattern to the boat’s existing rub rail or to the planned mounting surface. The pre-drilled 6 inch spacing matters when replacing an old rail, since using the same fastener spacing can reduce extra filling and drilling.

For a clean installation, the mounting surface should be fair, secure, and able to accept #12 fasteners. On curved sections, stainless rub rail usually requires careful handling and steady alignment so the polished face stays consistent along the boat’s sheerline.

Use cases on board

This rub rail is a practical match for powerboats, center consoles, cruisers, and refit projects where a stainless edge is preferred over vinyl or aluminum. It is especially useful on boats that see regular dockside contact, raft-ups, trailer loading, or tight marina slips.

The polished stainless finish also works well where the rail is a visible trim detail, not just a protective part. It helps preserve a finished look while adding a tougher contact surface at one of the most exposed points on the hull.

Maintenance and care

Rinse the rail with fresh water after saltwater use and clean it with products suitable for polished stainless steel. Avoid abrasive pads that can scratch the finish, and inspect the fasteners periodically so the rail stays tight against the hull through vibration, docking loads, and seasonal use.