Raymarine Suncover for Axiom Pro 9, Silicone, Trunnion Mount

Overview

The Raymarine A80534 is a silicone suncover made for the Raymarine Axiom Pro 9 display when the unit is trunnion mounted. It fits the 9-inch Axiom Pro helm display setup where the screen sits on its bracket rather than being flush mounted, giving the display face a practical cover when the electronics are not in use.

This cover is a straightforward replacement or spare for boats where the Axiom Pro 9 is exposed at the helm, flybridge, cockpit, or console. The silicone construction gives it a flexible feel for daily removal and refitting, which is useful when the boat moves between running, fishing, dockside storage, and washdown routines.

Key features

• Fits Raymarine Axiom Pro 9 displays when trunnion mounted.
• Silicone construction helps the cover sit securely over the display face without the stiffness of a hard plastic cover.
• Useful for exposed helm locations where sun, spray, dust, and dockside grime can reach the display between trips.
• Works as a replacement cover or as a spare to keep aboard for regular cockpit or console use.
• Product type is a display cover, so there are no electrical connections, voltage requirements, network settings, or software setup steps.
• Ships as a single cover, with commonly listed carton dimensions of 3 in high x 13 in wide x 19 in long and a package weight of 1.15 lb.

Compatibility and fit

This suncover is specific to the Axiom Pro 9 in a trunnion-mounted installation. It should not be treated as a universal Axiom cover, and it is not the correct reference point for flush-mounted or front-mounted Axiom installations unless that mounting style is separately confirmed against the vessel’s setup.

Use on board

For center consoles, pilothouse helms, fishing boats, and cruising boats with an exposed Axiom Pro 9, this cover helps keep the display protected during downtime. It is especially useful when the display stays mounted at the helm while the boat is stored, washed, trailered, or left at the dock.

Installation and care

No wiring, tools, or calibration are involved. Fit the cover over the display when the unit is powered down and not being used, then remove it before operating the chartplotter. Rinse off salt and grit before storage so the inside of the cover stays clean against the screen area.