Raymarine Trunnion Mount Suncover, For Axiom Pro 12, Black Silicone

Overview

The Raymarine A80535 is a black silicone suncover for the Raymarine Axiom Pro 12 display when it is installed in a trunnion mount. It gives the front of the display a clean protective cover when the unit is not in use, helping reduce exposure to cockpit sun, spray, dust, and dockside grime.

This cover is shaped for the 12-inch Axiom Pro display, so it is a fit-specific accessory rather than a universal GPS cover. The silicone construction helps it sit securely over the display face while still being easy to remove before getting underway.

The packaged item is listed with box dimensions of 2 in H x 9 in W x 15 in L and a weight of about 0.9 lb, which is useful when planning storage space on board or ordering it alongside other helm accessories.

Key features

• Fit-specific suncover for Raymarine Axiom Pro 12 displays in a trunnion mount setup.
• Black silicone cover helps shield the display face when the electronics are powered down or the boat is left at the dock.
• Useful for exposed helms, flybridges, center consoles, and other locations where the display sees sun, spray, and general deck traffic.
• Removable cover makes daily use simple, with no tools needed when uncovering the display before operation.
• Low-profile accessory that can be stowed easily when the chartplotter is in use.

Compatibility and fit

This suncover is for the Raymarine Axiom Pro 12 display. It is not a generic cover for all Axiom models, and it should be matched to the 12-inch Axiom Pro size before purchase.

The reference to trunnion mounting matters because helm displays can be mounted in different ways. This cover is intended for the Axiom Pro 12 when the unit is carried in its bracket rather than treated as a universal flush-mount cover.

Installation and use

Use the cover when the display is not being operated, such as while the boat is stored, docked, trailered, or sitting between runs. Before navigating, remove it fully so the screen, controls, card slots, and surrounding helm area are clear for normal use.

For owners replacing a lost or weathered cover, this is the matching Raymarine accessory for keeping the Axiom Pro 12 display covered without changing the electronics, wiring, network, or mounting hardware.

Care

Rinse salt and grit from the cover with fresh water before storing it, especially after offshore runs or washdowns. Let it dry before placing it in a locker so moisture and dirt are not trapped against other helm gear.