Plash Gravity Surface Mounted LED Deck Light, Stainless Steel Faceplate, Warm White Light, 3000K, 105 Lumens, IP67, 120 Degree Beam

Overview

The Plash Gravity Surface Mounted LED Deck Light is a warm white LED courtesy and deck light for boats that need a clean stainless steel look without a recessed cutout. It mounts on the surface, so installation is based on routing the wire, making the electrical connection, and fastening the light to a fiberglass roof, wall, deck area, cockpit liner, or other suitable boat surface.

This Gravity stainless steel warm white range is built around a 3000K LED output rated at 105 lumens, with a 1.2W power draw and a 120-degree beam angle. It is available in 12VDC and 24VDC versions, which makes it easier to match the light to the vessel’s existing DC system rather than adding a converter.

The IP67 rating suits exposed marine locations where spray, rain, washdowns, and damp air are part of normal use. A 9 ft tinned-copper power lead with a black insulated jacket helps with routing through liners, hardtops, and nearby wiring runs.

Key features

• Warm white 3000K LED light with 105 lumens for courtesy lighting, step lighting, cockpit accents, and deck area visibility.
• Surface-mounted format reduces the need for a large recessed cutout and works well on fiberglass roofs and walls.
• Available in 12VDC and 24VDC versions for common marine DC electrical systems.
• IP67 rating helps protect the light in wet, exposed, and washdown-prone areas on board.
• Low 1.2W power draw with amp draw listed at 0.2A on 12VDC and 0.1A on 24VDC.
• 120-degree beam angle spreads light across nearby deck, cockpit, or cabin surfaces rather than creating a narrow spot.
• Uses one 1W OSRAM LED for the light source.
• Includes 9 ft of tinned-copper 4-conductor power wire with a black insulated jacket for marine wiring runs.
• Stainless steel appearance pairs well with other polished or stainless hardware on deck and around the cockpit.

Variants

This Gravity warm white stainless steel range varies by faceplate style and voltage. The faceplate options are Cone, Dome, Eyelid, and Surface Mount, giving the installation a different finished look and light presentation while staying within the same surface-mounted Gravity deck light family.

The voltage options are 12VDC and 24VDC. The lighting specification stays centered on the same warm white platform, including 3000K color temperature, 105-lumen output, 1.2W power rating, 120-degree beam angle, IP67 protection, and a 9 ft tinned-copper lead.

Installation and setup

This light is meant for surface mounting, which is useful when the backside of the panel is hard to access or when a recessed light would require unnecessary cutting. On a boat, that can be a practical fit for hardtops, cabin sides, cockpit panels, steps, arch structures, or under-gunwale accent locations.

Match the selected 12VDC or 24VDC version to the vessel’s DC circuit before installation. As with any marine lighting circuit, use suitable circuit protection, sealed connections, strain relief, and wiring practices appropriate for the location.

Use cases on board

The warm white output works well where comfort and visibility matter more than high-intensity work lighting. It suits cockpit walkways, deck steps, transom areas, companionways, cabin entry points, and accent lighting near seating or helm areas.

This is a good match for boat owners and builders who want a small surface-mounted LED light with low current draw, a stainless steel look, and multiple faceplate choices for matching the style of the installation area.

Maintenance and care

Rinse the light with fresh water after heavy salt spray or washdowns, especially around the faceplate edge and mounting area. Avoid harsh cleaners or abrasive pads that can mark the finish, and inspect the wiring entry and fasteners during regular onboard maintenance.