TACO Marine Rigid Vinyl Canoe Rail, 1-1/4 in x 1-3/4 in, 16 ft 6 in, Black Rail

Overview

The TACO Marine V21-9140BKA166 is a black rigid vinyl canoe rail made for protecting and finishing the upper edge of a canoe while adding a built-in hand grip. It measures 1-1/4 inches high by 1-3/4 inches wide and comes in a 16-foot 6-inch length, giving boat owners a long rub rail profile for replacement work, restoration, or new installation.

This rail is a practical fit for canoes that need edge protection during docking, trailering, launching, and regular handling around the water. The same profile is also commonly used on deck boats, center consoles, and skiffs where its shape and grip-friendly form suit the hull or deck edge.

Key features

• Rigid vinyl canoe rail in black for a clean, low-glare finish along the boat edge.
• 1-1/4 inch height and 1-3/4 inch width help confirm profile fit before ordering.
• 16-foot 6-inch length suits long edge runs and replacement sections on canoes and small boats.
• Built-in hand grip gives the rail a useful hold point when moving, launching, or handling the boat.
• Adds structural support along the rail area when installed correctly on a compatible hull edge.
• Can be installed with #8 self-tapping screws, bolts, or pop rivets depending on the boat construction and repair approach.
• Made in the USA and backed by a 5-year limited warranty.

Installation and fit

Before installation, the existing rail profile should be compared against the 1-1/4 inch by 1-3/4 inch dimensions and the hull edge should be inspected for straightness, damage, and suitable fastening points. This is especially important on older canoes or small craft where the rail may also help tie the upper edge together.

The rail can be fastened with #8 self-tapping screws, bolts, or pop rivets. The right fastener depends on the hull material, backing access, and the level of service the boat sees. For saltwater use or boats stored outside, compatible corrosion-resistant hardware and proper bedding at fastener points help reduce water entry and staining.

Use on board

This rail is a good match for canoe owners replacing a worn edge rail, restoring a utility canoe, or adding a grip-friendly rub rail to a small workboat-style setup. It also suits builders and repair shops working on deck boats, center consoles, or skiffs where this profile matches the existing edge shape.

Once installed, it helps protect the rail area from everyday contact at docks, ramps, trailers, and storage racks. The black finish also blends well with many dark trim packages and utility-style boats without drawing attention away from the hull.

Maintenance and care

After installation, rinse the rail with fresh water after saltwater use and check the fasteners during seasonal maintenance. Any loose hardware should be corrected before the rail begins to work against the hull edge, especially on boats that are trailered often or handled by the rail during launch and recovery.