TACO Marine Flex Chrome Rub Rail Insert, 1 in x 1/4 in, 70 ft

Overview

The TACO Marine V12-9809CP70 is a 1 inch x 1/4 inch Flex Chrome rub rail insert supplied in a 70 foot length for replacing or refreshing the insert on a compatible boat rub rail profile. It gives the rub rail a chrome look while keeping the installation lighter and simpler than a stainless steel insert.

This insert is made for boats where the existing rub rail accepts a 1 inch high by 1/4 inch wide insert. The continuous coil helps create a clean run around the hull, transom, cockpit edge, or other rub rail sections with fewer interruptions, which is useful when restoring worn trim or finishing a rub rail replacement.

Key features

• 1 inch height and 1/4 inch width for matching compatible rub rail insert channels.
• 70 foot length supplied in a coil for working around long hull sections and curved rail runs.
• Chrome finish gives the rub rail the look of polished stainless steel without using a stainless insert.
• Flexible construction helps the insert follow curves along the boat’s rub rail profile during installation.
• No tools are required for installation when fitted into the correct compatible rub rail channel.
• Concealed-fastener appearance helps avoid exposed fasteners that can rust and interrupt the finished trim line.
• Made in the USA and backed by a 5-year limited warranty.

Compatibility and fit

Fit should be checked against the boat’s current rub rail channel before ordering. The key measurements are the 1 inch insert height and 1/4 inch width, since a rub rail insert must seat correctly in the existing profile to stay secure and sit flush.

This part is a practical match for owners replacing a faded, damaged, or missing chrome-look insert rather than replacing the entire rub rail system. It can also suit refit work where the goal is to restore the finished edge along the hull without adding metal trim.

Installation notes

For the cleanest result, remove the old insert and clean the rub rail channel before fitting the new coil. Work gradually around curves and corners so the insert seats evenly, especially near the bow and transom where the rail shape changes.

Because it is supplied as a flexible coil, the insert is easier to store and handle than long rigid pieces. This is helpful for repair shops, boatyards, and owners working in tight dockside or garage spaces.

Use on board

This Flex Chrome insert is well suited for cosmetic rub rail restoration on center consoles, runabouts, bay boats, cruisers, and other boats that use a compatible insert-style rub rail. It is most useful when the boat’s rub rail structure is still sound and the visible insert is the part that needs attention.