Ocean LED - Driver Power - for Pro Series HD Gen2 2010, 12VDC, 4A (001-500751)

Introducing the Ocean LED driver for Pro Series HD Gen 2 2010 / 3010 models - the perfect addition to your underwater lighting setup. Our lights require the right amount of electricity to function and perform at their best, and this driver provides just that.

Designed to run on low voltage 12VDC Volt Direct current electricity, this driver is the key to unlocking the full potential of your Ocean LED lights. It converts higher voltage, alternate current (AC) to low voltage, direct current (DC) to ensure your lights receive the correct amount of power they need.

Not only that, but this driver also protects your lights from voltage or current fluctuations. A change in voltage could cause a change in the current being supplied to our underwater lights. Too much or too little current can cause light output to vary or degrade faster due to higher temperatures within the LED. With our driver, you can rest assured that the voltage and current flowing through an LED circuit stays at its rated level, allowing your lights to shine bright for longer.

Included with Pro Series HD lights purchased, this driver is available in two different models to suit your needs. For the 2010 models, the driver provides a current of 4 Amps at 12 VDC and 2 Amps at 24 VDC, with a recommended fuse of 6.3 Amp and 3 Amp respectively.

For the 3010 models, the driver provides a current of 8.2 Amps at 12 VDC and 4 Amps at 24 VDC, with a recommended fuse of 10 Amp and 6.3 Amp respectively. With these options, you can ensure that your underwater lighting setup is perfectly suited to your needs and preferences.