Overview

The Garmin 010-10725-00 is a handlebar mount for Garmin Edge 205, 305, 605, and 705 devices that straps to the bar with zip ties.

It gives you a straightforward way to keep an older Edge unit secured on the bike for training rides, commuting, or shore runs when you keep bikes on board. It also works well as a replacement mount or as a second setup for another bike.

Key features

• Compatible with Garmin Edge 205, 305, 605, and 705 units.
• Zip-tie attachment keeps the mount in place without metal clamps or bolted hardware.
• Simple layout that suits common round handlebars and similar tubing.
• Useful as a replacement mount when an original bracket is worn or missing.

What’s included

• Handlebar mount
• Zip ties

Installation and setup

Place the mount on the handlebar where you want the Edge to sit, then thread the zip ties through the mount slots and around the bar. Tighten until the mount no longer twists by hand, then trim the zip-tie tails. After mounting the device, give it a quick tug check before you ride.

If you remove the mount for any reason, plan on using fresh zip ties when reinstalling so the mount stays snug and centered.

Compatibility and fit

This mount is intended for the older Garmin Edge 205, 305, 605, and 705 form factor. If you are using a newer Edge model, the interface and mount style may differ. The zip-tie method works best on round bars and rails where the ties can wrap evenly and sit flat against the mount.

Use on board and care

For boaters who carry bikes for rides ashore, leaving the mount installed on the handlebar keeps your Edge ready to attach as soon as you dock. After exposure to salt air or spray during storage, a quick fresh-water wipe-down helps keep the mount clean, and replacing zip ties periodically keeps the fit secure.