Overview

The Attwood Marine 11940-2 is a pair of 15 inch kayak foot braces with a trigger-lock adjustment system and a universal mounting hole pattern for a wide range of kayak layouts. It fits both sit-in and sit-on-top kayaks and gives you a firm bracing point for better leg drive, posture, and control while paddling.

This set works well as a replacement for worn foot pegs or as an upgrade on a kayak that needs a more secure foot position. The sliding adjustment makes day-to-day setup easier when the same boat is used by different paddlers, and the universal track pattern helps when matching existing mounting points or planning a fresh install.

Key features

• Pair of 15 inch foot braces for left and right foot support
• Trigger-lock adjustment lets you move the braces quickly to suit leg length and seating position
• Universal mounting hole pattern works with many sit-in and sit-on-top kayak hulls
• Lightweight design keeps added weight low in smaller paddle craft
• Mounting hardware is not included, so fasteners can be matched to your kayak hull and backing method

Compatibility and fit

These foot braces are a practical match for recreational and fishing kayaks that need more dependable lower-body support through long paddles, current, or rougher water. They also make sense on older boats where the original foot support is missing, worn out, or hard to adjust.

Before ordering, check that your kayak has enough sidewall space for a 15 inch rail assembly and compare the hole spacing with your current setup if you are replacing an existing brace. Because hardware is not included, you can choose the fasteners, washers, and backing pieces that suit the hull thickness and access inside your kayak.

Installation and setup

Installation is straightforward when the mounting area is accessible from inside the hull or through a hatch. Set both rails square to the seat position, test the full adjustment range before drilling, and make sure each side moves freely without interfering with seat frames, storage, or rudder control lines.

Once installed, the trigger lock makes it easy to fine-tune foot position on the water or at launch. That added adjustment is useful for shared kayaks, rental fleets, or any setup where paddler leg length changes from trip to trip.

Use on the water

A solid foot brace changes how a kayak feels under power. It gives you a stable point to push against so your stroke stays more controlled and your seated position holds up better over distance, especially when you are paddling into wind, moving through boat wake, or making repeated corrective strokes.

This setup suits paddlers who want a cleaner replacement part without adding unnecessary complexity to the boat. It is also a sensible choice for kayaks that need easier adjustment but do not require a full steering pedal system.