Overview

The Garmin 010-12256-12 is a watersport mount for VIRB Series action cameras, built for capturing footage when the camera needs to stay put through spray, vibration, and the occasional hard knock. It uses an adhesive mounting base and includes two safety tethers, so you have a backup connection if the mount gets hit or the gear goes overboard.

This mount is a good fit when you want a fixed viewpoint on smooth gear surfaces like a board, kayak, or similar watersport setup, and you still want the camera to come off quickly for charging and downloading footage. It is commonly used with VIRB X and VIRB XE.

Key features

• Watersport mounting kit for VIRB Series action cameras, including VIRB X and VIRB XE
• Adhesive base for mounting on smooth surfaces where clamps or straps are not practical
• Two safety tethers included for backup retention in rough water and impact-prone use
• Thumb-screw camera attachment for quick removal between sessions
• Low-profile mount shape helps keep the camera close to the surface to reduce snagging

Installation and setup

Adhesive mounts live or die by surface prep. Clean the mounting area thoroughly, remove wax or sunscreen residue, and make sure the surface is fully dry before applying the base. Press it down firmly and give the adhesive time to set before heading out, especially if the gear will flex or take repeated impacts.

Use the safety tethers as a true backup, not as the primary attachment. Tie them off to a solid point on the gear so the camera stays connected if something gets caught, a wave rolls the board, or the mount takes a direct hit.

Compatibility and fit

This mount is intended for VIRB Series action cameras. Confirm your camera model uses the VIRB mounting interface and that the mounting area has enough flat, smooth surface for the adhesive base to bond properly.

If you plan to mount on a boat, pick a spot that stays out of the way of lines, feet, and moving hardware. A clean mounting surface and a tether point you trust matter more on a boat because vibration and repeated washdowns can work on any adhesive setup over time.

Use on board

On the water, this mount is commonly used for tow sports clips, cockpit or bow perspectives, and deck-level shots where a handheld camera is not practical. It suits boaters and paddlers who want a consistent camera angle and are willing to take the extra minute to prep the surface and rig the tethers correctly.