TACO Marine Removable Side Mount Bracket, For Table Pedestal System, 316L Stainless Steel, Polished, 4-7/8 in W x 4 in H x 1/2 in D

Overview

The TACO Marine F16-0080 is a Type-316L stainless steel mounting bracket for a removable side mount table pedestal system. It gives the table pedestal a secure side mounting point while keeping the deck or cockpit sole clear of pedestal hardware and mounting holes.

This bracket is a practical fit for cockpit, deck, pontoon, and cabin table setups where space matters and the table needs to come out of the way between meals, fishing, docking, or moving around the boat. The bracket measures 4-7/8 in W x 4 in H x 1/2 in D, has a polished finish, and uses flat head screws with a 1/4 in mounting hole.

The side mount layout helps preserve foot room and clear passage on board. When paired with the matching side mount pedestal components, the locking pull pin and removable 125 degree bent leg make setup and removal simple in tight spaces.

Key features

• Type-316L stainless steel bracket with a polished finish for visible cockpit, deck, and cabin installations.
• Side mount configuration helps avoid pedestal mounting holes in the deck or cockpit sole.
• Locking pull pin adds holding strength at the bracket connection.
• Removable 125 degree bent leg supports quick table setup and removal when space is limited.
• Compact 4-7/8 in W x 4 in H x 1/2 in D size keeps the mounting point low profile on vertical surfaces.
• Flat head screw installation with a 1/4 in hole for a clean seated fastener fit.

Installation and fit

This bracket is meant for side mounting, so the mounting surface should be flat, strong, and positioned to support the table load without flexing. Common locations include vertical cockpit panels, bulkheads, console sides, and furniture bases where the table can be reached comfortably without blocking movement.

Before drilling, check the full table swing, pedestal angle, leg position, and clearance around seating, hatches, lockers, and walkways. The mounting surface should be backed or reinforced as needed for the boat structure and table size, especially on thin fiberglass panels or furniture modules.

Use on board

This bracket suits boats where a fixed table would get in the way during fishing, docking, boarding, or moving through the cockpit. It lets the table serve as a dining, prep, chart, or social surface when needed, then come off for clearer deck space and easier storage.

Because it uses a polished stainless finish and a compact side mount footprint, it can be used in visible areas without looking out of place alongside other stainless deck hardware and cockpit fittings.