Overview

The Simrad 000-13749-001 is a set of edge bezels for the NSS7 evo3 and Zeus3 7-inch multifunction displays. It trims the edge around the display opening so the install looks finished at the helm.

Use it during a new install or when refreshing a console where the original trim is missing or scuffed. It is made for these 7-inch models, so it lines up with the front housing and keeps the display’s controls and connections unchanged.

Key features

• Fits Simrad NSS7 evo3 and Zeus3 7-inch displays
• Adds a trim edge around the display face for a more finished look
• Helps hide minor gaps at the dash cutout
• Useful for helm refits, repanels, and replacement trim
• Installs as a physical bezel with no electrical connections

Compatibility and fit

Fits only the NSS7 evo3 and Zeus3 7 models. Confirm the exact model name on the unit label or in the system information menu, and verify you are working with the 7-inch version before ordering.

If your helm uses a different display size or a different NSS or Zeus generation, the bezel shape will not match the housing.

Installation and setup

Install the bezels after the display is mounted and aligned in the dash. Clean the surfaces where the trim will sit, then position the bezel pieces around the display face and fasten them using the attachment points on the display housing.

Use on board

This is a small finishing part that matters most on exposed helms where sunlight and spray make gaps and rough cut edges stand out. It suits boats being re-paneled, upgrading electronics, or cleaning up a cockpit console so the display looks integrated with the dash.