TACO Marine Rub Rail End Cap, 1-9/16 in, White Nylon, #8 Screws

Overview

The TACO Marine F90-0002WN is a 1-9/16 inch rub rail end cap used to finish the exposed end of compatible TACO rub rail on a boat hull. It is made from white nylon and sized for #8 screws, giving the rub rail a clean stopping point after a replacement, repair, or new installation.

This end cap is a practical detail part for keeping the rub rail termination neat at the bow, stern, transom corner, or another end point where the profile stops. It suits boat owners and repair shops replacing worn trim pieces, tidying up a rub rail job, or matching an existing white rub rail installation.

Key features

• Fits 1-9/16 inch rub rail applications where this TACO end cap profile is specified.
• White nylon construction suits white rub rail installations and common exterior boat trim locations.
• Accepts #8 screws for a straightforward mechanical fastening method.
• Compatible with TACO rub rail profiles V11-3161, V11-3447, V21-0456, V21-0460, V21-3671, and V21-9501.
• Sold as each, making it suitable for replacing a single missing or damaged end cap.

Installation and fit

Before installation, check the rub rail profile on the boat against the compatible TACO profile numbers and confirm the end cap width. The end of the rub rail should be cut cleanly and seated properly so the cap sits flush without forcing the nylon piece out of shape.

Use #8 screws that suit the mounting surface and the boat’s environment. On older hulls or previous repair areas, inspect the backing and screw holes before fastening so the end cap has a secure hold.

Use on board

This part is most useful during rub rail repairs, hull trim refreshes, and small collision or dock-rash repairs where the rub rail itself is still serviceable but the end cap needs replacement. Its white finish helps it blend with matching white rub rail sections used on many fiberglass boats.