TACO Marine Aluminum Rub Rail, 1-1/2 in x 5/8 in, 12 ft, Clear Anodized

Overview

The TACO Marine A11-0638TAL12D is a clear anodized aluminum rub rail base for protecting the hull-to-deck joint on many 16 to 24 ft boats. It measures 12 ft long, with a 1-1/2 in height and 5/8 in width, giving runabouts, center consoles, cuddy cabins, and small cruisers a clean metal rub rail profile for dockside contact and everyday handling.

This rail accepts a flexible vinyl insert, with TACO Marine V12-0338 commonly used as the matching insert and sold separately. The aluminum profile is drilled and countersunk for #8 fasteners on 6 in centers, which helps keep installation consistent along the sheer line when replacing worn rub rail or refitting a damaged section.

Key features

• 12 ft clear anodized aluminum rub rail base for hull-side protection and a finished edge at the hull-to-deck joint.
• 1-1/2 in height and 5/8 in width suit many small to mid-size powerboats in the 16 to 24 ft range.
• Accepts a flexible vinyl insert, so impact contact is handled by a replaceable insert rather than the aluminum base alone.
• Drilled and countersunk for #8 screws on 6 in centers to support even fastening along the rail.
• Anodized finish helps the aluminum stand up to saltwater exposure, spray, and regular washdowns.
• Flexible aluminum profile can follow curved boat sides during installation when handled with proper support and alignment.

Installation and fit

This rub rail is a practical match for repair work, restoration projects, and rub rail replacement where the existing profile and boat size line up with the 1-1/2 in by 5/8 in section. Before ordering, compare the rail height, width, fastener spacing, and insert style against the rail already on the boat or the rub rail specification for the hull.

The insert and mounting fasteners are not built into the rail, so they should be planned as part of the job. Dry-fitting the rail before final fastening helps confirm the bend, hole alignment, and transition around the bow and stern corners.

Use on board

Once installed, the rail helps protect the boat during docking, trailering, rafting up, and close-quarters movement around pilings or other boats. It is a good fit for owners replacing a tired aluminum rub rail base while keeping a traditional polished metal look with a separate vinyl insert for contact protection.