Attwood Marine Vinyl Grab Handle, One-Piece, 7-1/2 in Hole Centers, Hinged Fastener Covers

Overview

The Attwood Marine Vinyl Grab Handle is a one-piece boat grab handle made for adding a steady handhold on runabouts, fishing boats, jet boats, and similar marine or RV installations. It uses a polypropylene inner core with a molded vinyl cover, giving the handle structure while keeping the grip comfortable in everyday use around the cockpit, cabin entry, side panels, or deck-adjacent areas.

The handle has a molded, hinged fastener cover system built into the base. After the handle is secured, the covers close over the mounting points, so there are no separate caps to pop off and get lost. It installs with two #12 fasteners, using thru-bolting or wood screws, and the mounting hole pattern is 7-1/2 inches on center.

Key features

• One-piece vinyl grab handle for adding a secure handhold on boats, jet boats, runabouts, and RVs.
• Polypropylene inner core with a molded vinyl cover for use in demanding marine environments.
• Hinged fastener covers hide the mounting hardware and avoid loose removable caps.
• Shaped grip gives the hand a natural hold when boarding, moving through the cockpit, or bracing in choppy conditions.
• Installs with two #12 fasteners using thru-bolting or wood screws, depending on the mounting surface.
• 7-1/2 inch center-to-center mounting hole pattern fits many common replacement and new-install locations.

Variants

This grab handle is offered in two color configurations for matching different deck layouts, upholstery colors, console panels, or existing hardware.

The color is the variant attribute that changes between these options. The one-piece handle construction, molded vinyl cover, hinged fastener covers, #12 fastener installation, and 7-1/2 inch mounting hole spacing remain consistent across the listed variants.

• 2050-5: Color White. The white version works well with light gelcoat, white seating areas, and clean cockpit layouts where the handle should blend into the surrounding surface.
• 2054-5: Color Black. The black version pairs with darker trim, black canvas, console panels, or hardware where a stronger visual contrast is preferred.

Installation and fit

Mount the handle to a flat, solid surface that can support the load placed on a handhold. Thru-bolting is the stronger method where the back side of the panel is accessible, while wood screws can be used where the installation surface is suitable for that fastening method. The 7-1/2 inch hole spacing is useful when replacing an older grab handle or laying out multiple handles with a consistent pattern.

Because the fastener covers are hinged into the handle base, the hardware can be covered after installation without separate trim caps. This helps keep the finished installation tidy and reduces the chance of small parts coming loose over time.

Use cases on board

This handle is a practical match for cockpit sides, companionway areas, small cabin entries, helm-adjacent panels, and passenger seating zones where people need a simple place to steady themselves. It is especially useful on smaller powerboats and fishing boats where movement around the deck can be quick and space is limited.

Maintenance and care

Rinse the handle with fresh water after saltwater use and clean the vinyl cover with mild soap when needed. Avoid harsh solvents or abrasive pads that can damage the surface. During routine boat checks, confirm that the mounting fasteners remain tight and that the hinged covers are fully closed.