Hella Marine 6-Way Compact Switch Panel, 12V, 20A, Inline Fuses
-
Perfect Fit, Guaranteed
Get the right part every time
-
Expert Support
Our in-house specialists know our products inside and out
-
Enhanced Value & Service
We go beyond the sale with professional and balanced services
-
Wordwide Delivery
Enjoy hassle-free worldwide delivery
Overview
The Hella Marine 358114291 is a 6-way compact switch panel for 12V DC circuits, with a maximum load of 20A. It gives you six on/off toggle switches in a two-row layout, which is a tidy way to group common helm and console accessories without taking up much space.
The face measures 95 x 107 mm and the panel depth is 55 mm, so it fits well on smaller dashes and side consoles where clearance matters. Each switch is protected by a neoprene rubber boot to handle spray, and the inline fuses sit behind the panel for circuit protection without adding separate fuse blocks for these six runs.
Key features
- Six on/off toggle switches in a two-row layout for clean, easy labeling at the helm
- Splash-proof switch boots made from neoprene rubber for wet console conditions
- Inline fuse holders with fuses located behind the panel for built-in circuit protection
- Rated for 12V DC use with a maximum load of 20A
- Compact size: 95 x 107 x 55 mm (H x W x D) to suit tight mounting locations
- Impact-resistant plastic housing in a gray finish
- Includes a label set plus gasket and mounting hardware to finish the install neatly
Installation and setup
This panel is typically installed at the helm, in a side console, or on an electrical switch pod where it stays within reach but out of direct washdown streams. The gasket helps the panel sit cleanly against the mounting surface, and the included template makes it easier to lay out the mounting and panel opening accurately.
Plan for rear clearance so the wiring and fuse access stay serviceable after installation. Leave enough slack to pull the panel forward when you need to inspect or replace fuses.
Electrical and circuit planning
Use this panel on 12V DC systems and keep each circuit sized appropriately for the load and wiring run. High-draw gear that exceeds the panel rating should be switched through a relay or contactor, with the panel used as the control point.
It is a solid match for typical helm and utility loads such as navigation lights, cockpit or deck lights, electronics power feeds, pumps that fall within the rating, and other small onboard accessories where quick identification and fused protection matter.
What’s included
- 6-way compact switch panel (gray) with inline fuse holders and fuses
- Label set
- Mounting gasket
- Mounting screws
- Mounting template
We ship all in-store (FL) stock orders the same day if placed before 3 PM EST, Monday through Friday. Orders placed after this time will ship the next business day. Orders fulfilled from other warehouses or manufacturers may not ship the same day. If an item is out of stock, we will notify you promptly.