Victron Energy Extension Cable, For Blue Smart IP65 Chargers, 2 m

Overview

The Victron Energy 2 Meter Extension Cable is an accessory for Blue Smart IP65 Chargers with a DC connector, adding 2 m of reach between the charger and the battery connection lead.

It is used when the charger needs to sit farther from the battery bank, DC distribution point, or temporary charging position than the standard lead comfortably allows. On a boat, that can help keep the charger in a cleaner, more accessible spot while still reaching batteries in a locker, under a berth, or near an engine room service area.

The range is offered in 20 A and 25 A versions, so the cable can be matched to the charger output and the current requirement of the installation.

Key features

• 2 m extension length for Blue Smart IP65 Charger installations that need extra DC-side reach.
• Made for use with Blue Smart IP65 Chargers that have the Victron DC connector.
• Available in 20 A and 25 A maximum current versions to match the charger setup.
• Plug-style DC connection keeps installation cleaner than adding a loose splice into the charging lead.
• Useful for battery lockers, service compartments, and dockside charging layouts where the charger and battery are not mounted close together.

Variants

This product is offered in two current ratings for installations that use Victron Blue Smart IP65 Chargers with a DC connector.

The main difference between the variants is maximum current. The 2 m extension length and Blue Smart IP65 Charger accessory role remain consistent across the range.

• BPC900200014: Max Current 20 A. This version suits charger setups where the DC extension path does not exceed a 20 A rating.
• BPC900250014: Max Current 25 A. This version supports installations that need the higher 25 A current rating while keeping the same 2 m extension format.

Installation and fit

Use the cable on the DC side of the charger, between the Blue Smart IP65 Charger connector and the battery connection lead. The connector should be fully seated so the charging lead is secure before AC power is applied to the charger.

Route the cable where it will not be pinched by lockers, stepped on in a service area, or pulled tight when gear shifts underway. In marine spaces, it is good practice to keep DC charging cables supported, away from sharp edges, and clear of heat sources and moving engine components.

Use on board

This extension cable is a practical match for boats that use a portable or semi-permanent Victron Blue Smart IP65 Charger and need a little more working distance from the battery bank. It can be helpful for maintenance charging at the dock, seasonal battery care, or service work where the charger is kept outside a tight battery compartment.