TACO Marine Rigid Vinyl Rub Rail, 2-1/2 in x 7/8 in, 20 ft, Black

Overview

The TACO Marine V21-0458BKA20D is a black rigid vinyl rub rail for protecting and finishing the hull-to-deck joint on boats that need a substantial rub rail profile. It measures 2-1/2 inches high by 7/8 inches wide and comes in a 20-foot length, giving repair shops and boat owners a practical option for replacement work on skiffs, work boats, and other vessels that use this style of profile.

This is a rigid vinyl rail, so it gives the boat a clean outer edge while helping take the contact and scuffing that can happen around docks, pilings, trailers, and raft-ups. The profile is drilled and countersunk for #10 screws on 6-inch centers, which helps keep installation spacing consistent along the hull.

Key features

• Black rigid vinyl rub rail with a 2-1/2 inch by 7/8 inch profile for a substantial hull edge finish.
• 20-foot length for replacement sections or new rub rail installations on compatible boats.
• Drilled and countersunk for #10 screws on 6-inch centers to support a clean fastening pattern.
• Cuts and drills with standard woodworking tools, which helps during trimming and fitting.
• Requires heat for radius forming when working around curves in the hull.
• Made in the USA and covered by a 5-year limited warranty.

Installation and fit

Match the 2-1/2 inch height, 7/8 inch width, screw size, and hole spacing against the rub rail currently on the boat before ordering. Rub rail profiles can look similar at a glance, so checking the cross-section is important, especially on older hulls or boats that have had prior repairs.

During installation, the rail can be cut and drilled with standard woodworking tools. Heat is needed when forming the rigid vinyl around tighter radiuses, so the installer should work gradually and support the rail as it takes the curve. The pre-drilled and countersunk holes help keep the fasteners aligned and seated cleanly along the run.

Use cases on board

This rub rail is a good match for boats that need a tougher-looking black edge profile without a separate decorative insert. It suits working boats, utility skiffs, and other practical hulls where dock contact, trailer handling, and day-to-day use make the rub rail an important wear surface.