Overview

The Garmin 010-12673-04 is a replacement microSD card door that closes and protects the memory card slot on compatible Garmin chartplotters.

If your original door is cracked, missing, or no longer stays shut, this part restores a proper cover over the card opening so your chart card or data card stays secured while you run in spray, sun, and vibration.

Key features

• Replacement microSD card door for compatible Garmin chartplotters so the card slot can be closed again.
• Compatible with ECHOMAP Plus 92sv, 93sv, 94sv, 95sv, and 97sv.
• Compatible with ECHOMAP UHD 92sv, 93sv, 94sv, and 95sv.
• Also listed for GPSMAP 1242xsv.
• No wiring or software steps; it is a physical door replacement at the card compartment.

Compatibility and fit

This door is specific to the Garmin units listed above. Check the model name on the front bezel or the product label on the back of your display before ordering, since other screen sizes and series use different card doors.

Installation and setup

Power the unit down, access the card compartment, and swap the damaged or missing door for the replacement. Once installed, confirm the door closes fully and stays latched before heading offshore or doing a cockpit washdown.

Use on board

This is a practical fix for boats that regularly move chart cards between units, load mapping, or keep a data card installed for day-to-day use. A properly closing card door also helps keep grime and salt spray from collecting around the card slot.

Maintenance and care

After rough weather or washdowns, wipe the card area clean and make sure the door is free of salt crystals so it can close normally. Avoid forcing the door if sand or dried salt is present; rinse and clean the area first.