TACO Marine 3-Rod Aluminum Rod Rack, For Light Tackle Spinning Rod/Reel Combos, 8-1/2 in H x 12 in W, 1-1/2 in ID, Brushed Anodized Aluminum

Overview

The TACO Marine F31-3003BSA-1 is a surface-mount 3-rod aluminum rack for storing light tackle spinning rod and reel combos on board. It measures 8-1/2 inches high by 12 inches wide and uses 1-1/2 inch rod holder openings, giving anglers a tidy place to keep up to three setups ready without taking over deck or cockpit space.

The rack has a brushed anodized aluminum finish for a clean match with common boat hardware, along with hidden fasteners that keep the installed face neat. A slotted holder layout helps lock rods and reels in place, while the form-fitted black PVC liner gives the rods a protected contact surface inside the holder openings.

Key features

• Holds up to three light tackle spinning rod and reel combos in one surface-mounted rack.
• 8-1/2 inch height and 12 inch width help it fit bulkheads, console sides, cockpit areas, leaning posts, and other flat mounting locations.
• 1-1/2 inch rod holder inside diameter supports compatible rod handles without oversizing the rack.
• Brushed anodized aluminum finish gives the rack a finished look that works well with marine hardware and boat interiors.
• Hidden fasteners keep screw heads out of sight after installation for a cleaner mounted appearance.
• Slotted openings help rods and reels stay seated when the boat moves or when gear is handled between casts.
• Form-fitted black PVC liner helps reduce direct contact between rod handles and the aluminum holder body.
• Covered by a 3-year limited warranty.

Installation and fit

This rack is a good match for boats that need rod storage in a compact, visible spot rather than a recessed gunwale holder. It is meant for a flat mounting surface, so common locations include the side of a console, a cockpit bulkhead, a cabin wall, a dock box area, or a tackle station where rods need to stay organized and easy to grab.

Before drilling, check that the 12 inch width and 8-1/2 inch height clear nearby hatches, cushions, rails, and walking paths. The mounting surface should be strong enough to support the loaded rack, especially where vibration, wave impact, and repeated rod handling are part of normal use.

Use cases on board

For inshore fishing, bay boats, center consoles, pontoons, and small cruisers, this rack keeps light spinning outfits grouped together instead of leaning loose against seats or coamings. It also works well as dockside or garage storage for rods that move between the boat and shore.

The brushed aluminum face makes sense where the rack will be seen, not hidden away in a locker. It suits owners who want organized rod storage with a finished appearance and simple access during a fishing day.

Care and maintenance

Rinse the rack with fresh water after saltwater use and wipe away grit around the liner openings so rod handles slide in cleanly. Check the mounting hardware from time to time, especially after trailering or rough-water runs, to make sure the rack remains tight against the mounting surface.