Overview

The Hella Marine 958000011 is a white plastic 45 degree mounting bracket for Hella Marine LED surface strip lamps with a switch.

It is a holder that changes the lamp’s mounting angle, which helps when a flat mount would aim light straight out instead of down onto the area you are trying to illuminate.

On boats, this is most often used under a hardtop, along a cabin side, or on a bulkhead where you want the strip lamp to sit cleanly on the surface while still throwing light down onto steps, side decks, or cockpit seating.

Key features

• Fixed 45 degree mounting angle for surface strip lamp installations.
• Helps aim light down onto walkways and work areas when mounting on a vertical or sloped surface.
• White finish that blends with common gelcoat, liners, and headliners.
• Useful for refits where the mounting location is already set but the beam direction needs to change.

Compatibility and fit

This bracket is meant to suit Hella Marine surface strip lamps with a switch. Before ordering, match the lamp family and mounting footprint on your boat, since strip lights from different ranges can look similar but use different mounting patterns.

Installation and setup

Dry-fit the bracket and lamp together so the beam lands where you need it, then mark and drill for your mounting surface. On cored panels, seal fastener holes properly to keep moisture out of the core. If the lamp wiring runs behind the mounting area, leave enough service loop for strain relief and keep connections protected from spray.

Use on board

This is a good match for coastal cruisers and fishing boats that use surface strip lights in cockpits, under gunwale overhangs, or along cabin sides and want better light placement without moving the lamp to a new location.