TACO Marine Stand-Off Surface Mount Rod Holder, 1-3/4 in ID

Overview

The TACO Marine P04-0111W is a white stand-off surface mount rod holder for adding fixed rod storage to a boat without cutting a large tube-style opening into the mounting surface. It has a 1-3/4 in. inside diameter and uses UV-stabilized high-density polyethylene, which makes it a practical fit for exposed cockpit, pontoon, console, or side-panel locations where sun, spray, and routine washdowns are part of normal use.

The stand-off layout keeps the rod holder raised from the surface, giving better clearance for the rod and reel than a flat clip-style holder. A front access hole helps with fastening during installation, and the included stainless-steel hardware is a useful detail for saltwater and freshwater boats where ordinary hardware can stain or corrode quickly.

Key features

• Stand-off surface mount format for permanent rod storage on suitable flat boat surfaces.
• 1-3/4 in. inside diameter for checking fit against the rod handles used on board.
• UV-stabilized high-density polyethylene construction in white for exposed marine locations.
• Integrated standoffs help create clearance between the holder and the mounting surface.
• Front access hole supports cleaner fastening during installation.
• Stainless-steel hardware is included for use in wet marine environments.
• Made in the USA.

Installation and use

This holder is meant for surface mounting, so installation starts with selecting a solid backing area that can take the fasteners and the load from stored rods. Common locations include pontoon rails with suitable panels, cockpit side panels, console sides, transom areas, and other flat surfaces where the rod will not interfere with seating, controls, lines, or walkways.

Before drilling, check the rod angle, handle diameter, reel clearance, and the space behind the mounting surface. The front access hole and stand-off shape make the install more straightforward than a flush-mounted tube holder, especially where access behind the panel is limited.

Compatibility and fit

The key fit point is the 1-3/4 in. inside diameter. It works as a storage holder for rods with handles that fit that opening, but the final fit should be checked against the actual rods used on the boat, especially larger offshore rods, rods with oversized grips, or setups with bulky reel seats.

This is a good match for boat owners who want tidy rod storage for fishing days, dockside organization, or keeping extra rods off the deck during coastal cruising and family boating. It is not an electronics or networked accessory, so there are no 12V, 24V, or NMEA integration requirements.

Maintenance and care

Rinse the holder with fresh water after saltwater use and during regular boat washdowns. Keeping sand, salt, and bait residue out of the holder helps the polyethylene surface stay clean and helps the stainless hardware remain in better condition over time.

What’s included

• White stand-off surface mount rod holder
• Stainless-steel mounting hardware