Overview

The Garmin 010-C1171-00 is a Standard Mapping electronic chart card that covers Louisiana West (Classic) on microSD/SD media for use in a compatible chartplotter.

It replaces the basemap with a sectioned coastal aerial overlay so waterways and land features are easier to pick out at a glance, and it adds high-contrast offshore elevation shading for clearer offshore detail. Local names are shown for many waterways and landmarks, which helps when you are lining up what is on the screen with what is around you.

Key features

• Louisiana West Classic coverage on a preprogrammed microSD/SD chart card
• Sectioned coastal aerial overlay that replaces the basemap
• High-contrast offshore elevation shading for easier offshore reading
• Local names shown for waterways and land features
• For compatible chartplotters that support Standard Mapping chart data and accept microSD or full-size SD cards

Compatibility and fit

This chart is meant to be read directly by a chartplotter with a card slot. Confirm your unit supports Standard Mapping chart data and check whether it takes microSD or full-size SD before ordering.

Fishfinders that do not accept mapping cards cannot use this product.

Installation and setup

Insert the card into the chartplotter’s memory-card slot, then power on and allow the unit to load the chart data. A short load time is normal, and the unit may prompt you to switch the chart source to the inserted card.

If the chart does not appear right away, open your chart settings and verify the inserted chart source is enabled, and make sure your chartplotter software is up to date.

Use on board

This coverage is a good fit when you spend time navigating and fishing along Louisiana’s west coast where aerial detail and local names make it easier to identify cuts, shorelines, and familiar landmarks. It also helps on coastal runs when you want offshore shading to give better visual context on the chart page.

Care and handling

Keep the card and contacts clean and dry, and store it in its case when it is not in the plotter. If your unit records sonar logs, Quickdraw data, or updates from a card, use a separate blank memory card for those tasks so the chart data stays untouched.