Victron Energy RJ45 UTP Splitter Cable, For MultiPlus 500VA-1600VA, 1x Male to 2x Female, 15cm

Overview

The Victron Energy ASS030065510 is an RJ45 UTP splitter cable with one RJ45 male connector, two RJ45 female connectors, and a 15 cm cable length. It is used in Victron VE.Bus installations where a single RJ45 connection needs to feed two VE.Bus ports, including MultiPlus 500VA to 1600VA systems configured for parallel operation or three-phase setups.

This is a small but important connection piece for tight electrical spaces on board, such as inverter charger compartments, DC distribution areas, and equipment panels where extra cable length or bulky adapters can make the installation harder to keep tidy. The short lead helps reduce clutter while still giving enough movement to route the two female RJ45 sockets where they can be accessed during setup or service.

Key features

• RJ45 UTP splitter cable for Victron VE.Bus communication layouts.
• One RJ45 male connector to two RJ45 female connectors for installations that require multiple VE.Bus ports.
• 15 cm cable length helps keep wiring neat in compact marine electrical compartments.
• Suitable for MultiPlus 500VA to 1600VA systems used in parallel and three-phase configurations.
• Useful for clean routing around inverter chargers, control wiring, and nearby Victron communication cables.

Installation and setup

Use this splitter as part of a planned Victron VE.Bus layout rather than as a general Ethernet network switch. It is meant for the specific RJ45-style communication connections used by compatible Victron equipment, so the system layout should match the VE.Bus requirements for the inverter charger arrangement being installed.

In a boat installation, secure the connected cables so the splitter is not carrying cable weight or being pulled by vibration. Leave enough slack for service access, but avoid loose loops near high-current DC cabling, sharp panel edges, or areas where gear may shift underway.

Compatibility and fit

The main fit points are the RJ45 male to dual RJ45 female configuration and the 15 cm cable length. This format works well when the splitter needs to stay close to the Victron device, with the two female sockets positioned for short VE.Bus cable runs.

This splitter is a practical match for owners, installers, and refit technicians working on Victron MultiPlus 500VA to 1600VA systems where parallel or three-phase communication cabling is part of the build. It is also useful in other VE.Bus layouts where more than one VE.Bus port is required and the installation space benefits from a short, tidy adapter.