Overview

The Raymarine R70159 is a 1.5 m power cord for Raymarine a-Series multifunction displays, including the a65, a67, a75 and a77. It is used to bring power to the display at the helm, console or nav station when replacing a missing lead, refreshing an older installation or keeping a spare cable on board.

This cord is a model-specific accessory, so fit depends on the display rather than the vessel type. For a clean installation, check the display model on the unit before ordering and route the 1.5 m cable with enough slack for service access while keeping it protected from chafe, sharp bends and vibration.

Key features

• 1.5 m cable length for short power runs behind a helm, dash panel or electronics pod.
• Fits Raymarine a65, a67, a75 and a77 multifunction displays.
• Useful as a replacement power cord when moving a compatible display to a new boat or restoring an existing a-Series installation.
• Model-specific Raymarine accessory, which helps avoid adapting a generic power lead at the display connection.
• Suited to marine electronics layouts where cable routing space is limited and excess cable should be kept manageable.

Compatibility and fit

This power cord is for the Raymarine a-Series display family listed above. It is not a general-purpose electrical cord set for every Raymarine display, and it should not be selected for other chartplotter families unless the display documentation or existing cable match confirms the same connection.

Installation and setup

Before installation, disconnect power to the electronics circuit and inspect the display power port for corrosion, bent pins or damage. Run the cable where it will not be pinched by panel hardware, steering components or service covers, and secure it so vibration at the helm does not load the connector.

After connection, verify polarity, circuit protection and the condition of the boat’s power feed according to the display installation requirements. A clean power feed is especially important on boats with shared electronics circuits, high-current accessories or long cable runs back to the battery switch panel.

Use cases on board

This cord is a practical match for owners servicing a compatible Raymarine a-Series helm display, marine electronics installers replacing a lost or damaged cable, and boat refit projects where an a65, a67, a75 or a77 is being reused in a new panel layout.