Overview

The Garmin 010-11814-02 is a wrist strap replacement kit for compatible Garmin fenix watches, built around a fabric strap with a hook-and-loop fastener and an extender strap. It is meant for situations where you want quick adjustment on the wrist or over gear without dealing with a buckle.

On a boat, that adjustability matters when you move between bare wrist, gloves, and foul-weather layers. The kit includes the small parts and tool needed to swap the strap, so you can replace a worn band before it fails on deck or keep a spare aboard for longer trips.

Key features

• Fabric strap with a hook-and-loop fastener for fast fit changes with wet hands or gloves.
• Extender strap for wearing the watch over a jacket sleeve or thicker cold-weather layers.
• Screw-pin attachment hardware and connector lugs for a complete strap change, not just the band.
• Torx tool included for removing and reinstalling the screw pins during the strap swap.

What’s included

• Fabric wrist strap
• Extender strap
• Screw pins
• Connector lugs
• Torx tool

Compatibility and fit

This kit uses connector lugs secured by screw pins. Before ordering, check your current watch band attachment and confirm it matches this screw-pin and lug style. If your watch uses a different mounting method, the parts in this kit will not seat correctly.

Installation and setup

Plan to work over a clear surface so the small hardware cannot roll away. Remove the existing screw pins with the included Torx tool, transfer or install the connector lugs as needed, then install the new strap and reinstall the screw pins. Tighten until secure, but avoid forcing the threads.

Use on board and care

This strap setup is a good match for skippers and crew who wear their fenix on deck and often switch between a bare wrist and outer layers. After saltwater exposure, rinse the strap and hardware with fresh water and let it air dry to keep the hook-and-loop closure working smoothly.