Overview

The Perko 0958DP0CHR is a surface-mount drawer pull for boat drawers, cabinet doors, and storage compartments, made from chrome-plated zinc alloy with an overall width of 3-7/16 inches, an inside width of 2-5/16 inches, and mounting points sized for #6 screws.

This is the kind of exposed pull that works well when you want a full handhold on a locker front instead of a small knob or a recessed handle. On board, it fits neatly into cabin joinery, galley storage, and other interior compartments where easy access matters and where the chrome finish can match nearby hardware.

Key features

• Surface-mount pull that installs without cutting a recess into the panel.
• Chrome-plated zinc alloy body with a plated finish that pairs well with other chrome hardware in the cabin.
• 3-7/16 inch overall width with a 2-5/16 inch inside opening for a grip that is easier to catch than a small knob.
• Uses #6 screws, which helps when replacing a pull on cabinetry already drilled for this common fastener size.
• Useful on drawers, cabinet fronts, and storage compartments where a simple grab handle is all that is needed.

Installation and fit

Because it mounts on the surface, installation is straightforward on flat drawer fronts and cabinet faces. Check the available clearance around the pull before drilling so fingers can wrap the inside opening comfortably and the handle does not interfere with nearby trim or adjoining doors.

If you are replacing an existing pull, compare the overall width, inside width, and screw size before ordering. That quick check is usually what tells you whether this will be a clean swap or whether the old mounting pattern will need to be reworked.

Use on board

This pull is a good match for boat owners updating cabin cabinetry, galley drawers, or small locker fronts where an exposed handle is easier to use underway. It makes the most sense in interior or otherwise protected mounting locations where plated cabinet hardware is commonly used.