Overview

The Garmin ECHOMAP Ultra 2 is a protective cover that goes over a compatible ECHOMAP Ultra 2 chartplotter when the screen is not in use. It is offered in size-matched versions for 10 inch, 12 inch, and 16 inch displays, so the fit stays close to the bezel at the helm.

On a boat, leaving the plotter face exposed at the dock or on the trailer invites salt film, cockpit dust, and scuffs from gear moving around. This cover helps keep the display area shielded between runs without adding anything permanent to your mount.

Key features

• Made specifically for Garmin ECHOMAP Ultra 2 chartplotters and sized by display size.
• Covers the display when the unit is not in use to help keep grime and spray off the screen and controls.
• Useful for storage, transport, and routine washdowns where the helm gets wet or dusty.
• Quick to install and remove, so the unit can be covered at the end of a trip and uncovered at launch.

Variants

This cover is available in multiple configurations to match different ECHOMAP Ultra 2 screen sizes.

The only change between variants is the size of the cover, which corresponds to the screen size of the ECHOMAP Ultra 2 chartplotter it is meant to fit.

• 010-13352-00: Size 10 inch. Fits ECHOMAP Ultra 2 chartplotters with a 10 inch display.
• 010-13352-01: Size 12 inch. Fits ECHOMAP Ultra 2 chartplotters with a 12 inch display.
• 010-13352-10: Size 16 inch. Fits ECHOMAP Ultra 2 chartplotters with a 16 inch display.

Compatibility and fit

This is intended for the ECHOMAP Ultra 2 family. If your chartplotter is a different ECHOMAP, GPSMAP, or another series, the bezel shape and button layout can differ, so confirm the model line and screen size before ordering.

Installation and everyday use

Slip the cover over the front of the chartplotter after you power down and wipe the screen. It fits well for boats that live on a lift, at a slip, or on a trailer where the helm sees sun, salt air, and dockside grime between outings.

Maintenance and care

Rinse off salt and wipe it clean as needed before stowing. A soft cloth with mild soap and water is usually enough; avoid harsh solvents that can leave the surface tacky or hazy.