Overview

The Simrad 000-13700-001 is a replacement bezel for Simrad GO9 and B&G Vulcan 9 9-inch multifunction displays, used to restore the finished edge around the front of the unit.

If the original bezel is scratched, cracked, or sun-faded from years at the helm, replacing it freshens up the look of your install without changing any wiring, power connections, charts, or network settings.

This is a size-specific trim piece, so matching it to the correct display model matters for a clean fit on a bracket mount or a flush-mounted dash.

Key features

• Fits Simrad GO9 and B&G Vulcan 9 9-inch display housings
• Replaces the outer front trim/bezel to clean up the edge of the display at the helm
• No electrical or network connections involved
• Useful during refits and dash updates where the display face needs a tidy, finished perimeter

Compatibility and fit

Compatible with Simrad GO9 and B&G Vulcan 9 (9-inch) displays. Confirm the model on the unit label or startup screen before ordering, since bezels are matched to the display size and housing.

It is not intended for other GO or Vulcan sizes, even when the units look similar from a distance.

Installation notes

Do the swap with the display powered off and supported so the screen is not taking any pressure. If your unit is flush-mounted, loosening it enough to access the bezel edge makes the job easier and helps avoid slipping tools near the glass.

Once installed, wipe the bezel and surrounding dash area clean so grit does not work under the trim with vibration.

Maintenance and care

Rinse salt residue with fresh water and wipe with a soft cloth. Skip harsh solvents and abrasive pads, which can dull plastic trim over time.

This part makes the most sense for open helms that see full sun and frequent washdowns, or for owners who want their electronics to look finished again without replacing the entire display.