Overview

The Hella Marine 995002021 is a 2 nautical mile all-round anchor lamp for showing your boat’s position at night with 360-degree visibility. This listing is identified as Red, Black, so it is worth confirming the lamp’s visible color and housing finish match the look you want and the light function you are installing.

It sits within Hella Marine’s 2010 Series all-round lamp range, which is commonly installed on a pole or base system to suit different mounting locations on powerboats and sailboats. On most boats, this type of light ends up on a mast, hardtop, radar arch, or other high point where it can be seen without being blocked by antennas, canvas, or gear.

Key features

• 2 nautical mile all-round anchor lamp format for clear, 360-degree visibility around the vessel
• Part of the 2010 Series all-round lamp range with multiple pole lengths and base styles across the family
• Saltwater-resistant and non-magnetic construction traits suited to typical topside mounting
• Impact-resistant base construction is used within the series where a pole-mounted light sees knocks and vibration

Compatibility and fit

Before ordering, confirm where you plan to mount it and what your current setup expects: a deck base, a pole base, or a direct mount on a flat surface. All-round lights only do their job when they sit upright and have an unobstructed view around the boat, so the mounting height and nearby hardware matter as much as the light itself.

If you are replacing an existing 2010 Series lamp, check that the base type and pole length match what is already on the boat so the new unit drops in cleanly without changing hole patterns or cable routing.

Installation and wiring

Plan the cable run so it stays protected from chafe inside the pole or under the mounting surface, then seal any deck penetrations properly to keep water out of the core. On open boats, pay extra attention to strain relief where the wire exits the base or pole so vibration does not work-harden the conductors over time.

Use marine-grade, tinned wiring and sealed connections where the harness is exposed. If your boat already has a dedicated anchor-light switch and fuse, keep the circuit protection in place and verify the light is on the correct switch position after installation.

Use on board

This style of all-round anchor lamp fits boats that spend nights at anchor or on a mooring and need a clear, elevated light that can be seen from any direction. It is also a straightforward replacement path for owners who already have a pole-mounted all-round light and want to keep the same general mounting approach.

Maintenance and care

Rinse salt spray off the exterior during regular washdowns and keep the lens clean so light output is not dulled by film or staining. During seasonal checks, inspect the mounting fasteners, confirm the light stays vertical, and look over the wiring at the base for early signs of corrosion or abrasion.