Perko Surface Mount T-Handle Latch, Non-Locking, 2-1/2 in Hole, 1/8-3/4 in Surfaces

Overview

The Perko 1092 is a non-locking surface mount latch for smooth and carpeted marine surfaces, built for hatches, storage lids, compartments, and access panels where a low-profile T-handle is preferred over a keyed lock. It installs in a 2-1/2 inch diameter mounting hole, fits mounting surfaces from 1/8 inch to 3/4 inch thick, and has a 3 inch face plate diameter.

This latch uses a polymer body, a chrome handle, and a stainless steel stem, giving boat owners a practical latch for areas exposed to vibration, spray, and regular deck use. The T-handle drops down flush in either the open or closed position through 180 degrees of rotation, except when an offset cam bar is positioned upward.

A rubber seal and boot sit under the T-handle to help reduce water intrusion around the handle area. The range covers black and white body colors with several cam bar options, so the latch can be matched to the hatch surface, trim color, and required grip range.

Key features

• Non-locking surface mount latch for marine hatches, lockers, deck compartments, and access panels.
• Made for use on smooth or carpeted mounting surfaces.
• Installs in a 2-1/2 inch diameter hole and fits surfaces from 1/8 inch to 3/4 inch thick.
• 3 inch face plate diameter gives the latch a clean finished look around the cutout.
• T-handle sits flush in the open or closed position with 180 degrees of rotation, except when used with an offset cam bar positioned upward.
• Polymer body with chrome handle and stainless steel stem for common marine hatch and compartment applications.
• Rubber seal and boot under the T-handle help limit water entry around the handle area.
• Available in black or white body colors with multiple cam bar ranges for different latch depths.

Variants

The Perko 1092 range varies by body color and cam bar adjustment. The listed configurations use either a black or white body with a chrome handle, and the cam bar option changes the latch reach for different hatch, lid, or compartment setups.

Some versions are supplied with no cam bar, while others include adjustment ranges from 1/2 inch to 3 inches or use the 1075DP0CHR slam cam bar option. Match the body color to the surrounding surface and match the cam bar range to the depth needed behind the panel.

Installation and fit

For a clean installation, confirm that the hatch or compartment surface can accept a 2-1/2 inch hole and that the material thickness is within the 1/8 inch to 3/4 inch range. The 3 inch face plate covers the opening and gives the latch a finished appearance on cockpit lockers, deck boxes, seat bases, and cabin storage panels.

The cam bar selection matters because it determines how the latch engages behind the panel. A shallow hatch lip may need a shorter range, while a thicker lid, liner, or carpeted surface may require a longer adjustment range.

Use on board

This latch is a good fit for boat owners replacing worn compartment hardware or adding a flush T-handle latch where security from a key is not required. It works well for storage spaces that need quick access during fishing, cruising, or dockside use, especially where a raised handle would snag gear or lines.

The flush handle layout also helps keep hatch tops and compartment lids easier to move around, clean, and step near, while still giving enough grip to open the panel by hand.

Materials and care

The polymer body and stainless steel stem suit typical marine latch duty, and the chrome handle gives the visible hardware a finished look. Rinse the latch with fresh water after salt exposure, keep grit out from under the handle, and check the cam bar adjustment during routine hatch and locker maintenance.