TACO Marine ShadeFin Fixed Clamp-On Mount, 3/4 in or 1 in Pipe, 1-1/4 in Tube, 316L SS

Overview

The TACO Marine T10-3000-11 is a fixed clamp-on mount for attaching a ShadeFin to existing pipe or tube when the boat has limited rod-holder options. It fits 3/4 inch or 1 inch schedule-40 pipe, as well as 1-1/4 inch O.D. tube, making it useful on many T-tops and similar rail structures.

This mount is made from polished Type-316L stainless steel, a practical choice for hardware that lives around saltwater, spray, UV exposure, and regular washdowns. The fixed clamp-on layout keeps the ShadeFin attachment point simple, with a guide notch for accurate placement and a pin-locking hole to help keep the setup secure once installed.

Key features

• Fits 3/4 inch or 1 inch schedule-40 pipe and 1-1/4 inch O.D. tube for use on compatible T-top piping and rail structures.
• Fixed clamp-on format gives boats without a suitable rod holder a dedicated ShadeFin mounting point.
• Polished Type-316L stainless steel construction suits exposed marine locations where corrosion resistance matters.
• Guide notch helps position the ShadeFin accurately during setup.
• Self-aligning notch and pin-locking hole help the mount stay properly located once the ShadeFin is installed.
• Made in the USA and covered by a 1-year limited warranty.

Installation and fit

This mount is intended for compatible round pipe or tube, so the key fit check is the outside diameter and pipe type at the mounting location. Before installation, confirm that the chosen section of T-top piping or rail is straight, accessible, and clear of canvas, antennas, outriggers, rod holders, lights, and other hardware that could interfere with ShadeFin movement or coverage.

Because this is a fixed mount, placement matters. Mounting it where the ShadeFin can open cleanly and cast shade over the cockpit, helm, aft deck, or other active area will give the best result without adding unnecessary hardware to the boat.

Use cases on board

This clamp-on mount is a good match for center consoles, bay boats, and fishing boats that use a ShadeFin but do not have a convenient rod holder in the right location. It can also help when the preferred shade position is on existing T-top structure rather than in a gunnel or hardtop-mounted rod holder.

Maintenance and care

After saltwater use, rinse the mount with fresh water and check the clamping area during routine cleaning. Keeping the polished stainless surface free of salt buildup and inspecting the locking points helps maintain a clean fit and dependable operation through repeated setup and removal.