Overview

The Garmin 010-12548-00 is a trim piece snap cover for Garmin GPSMAP 7x2 series chartplotters. It replaces the small bezel trim cover that snaps on after the unit is mounted, bringing back the finished look when the original trim is missing or damaged.

This is not a protective sun cover for the screen. It is the snap-on trim/bezel piece used at the helm, often the part that goes missing during service work behind the dash or when a display is removed for storage.

Key features

• Made to fit Garmin GPSMAP 7x2 series chartplotters
• Snap-on trim piece used to restore the clean, finished bezel edge after mounting
• Black color to match the factory chartplotter bezel appearance
• Handy replacement part to keep a helm refit or electronics service from leaving the installation looking unfinished

Compatibility and fit

Fit is series-specific. Confirm your chartplotter is in the GPSMAP 7x2 family before ordering, since trim pieces for other GPSMAP series and sizes do not share the same shape and snap points.

Installation and setup

The cover presses into place on the chartplotter trim/bezel area. Before installing, wipe away salt film and grit so the snap features seat fully and the cover sits flush.

Use cases on board

This part is a good match for boats where the chartplotter is mounted at the helm and gets pulled occasionally for wiring access, upgrades, or seasonal storage. It is also useful after a used-electronics purchase where trim pieces are often missing.

Maintenance and care

Rinse with fresh water after salty runs and wipe dry. Avoid harsh solvents that can dull or haze trim finishes.

Regulatory information

This product carries a California Proposition 65 warning.