Overview

The Garmin 010-12548-02 is a trim piece snap cover that replaces missing or damaged trim on GPSMAP 10x2 Series 10-inch chartplotters.

It is the small snap-in trim that finishes the edge of a flush-mounted unit, helping the helm installation look clean after a service pull, refit, or a trim cap that cracked or went missing. This is not a sun cover that goes over the display when the boat is parked.

Key features

• Made to fit GPSMAP 10x2 Series 10-inch chartplotters
• Snap-in trim cover used around the edges of a flush-mounted installation
• Restores the finished look when an original trim piece is lost, broken, or removed during service
• No wiring or network setup involved since it is a physical trim component only
• Helps keep the perimeter of the cutout tidy where hands and lines can brush past the helm

Compatibility and fit

This trim piece is specific to the GPSMAP 10x2 family. Before ordering, confirm your chartplotter series on the unit label or in the system information menu, since other GPSMAP sizes and series use different trim parts.

Installation and setup

With the chartplotter already mounted, the trim cover snaps into place around the edge of the unit. If you are removing an old piece first, use a plastic pry tool and work gently from the corners to avoid marking the bezel or surrounding dash panel.

Use on board

This part is a practical match for boats with a flush-mounted GPSMAP 10x2 at the helm where the trim has been removed during upgrades, where a corner trim cap was lost, or where the finish around the cutout needs to be restored after maintenance.

Maintenance and care

Rinse with fresh water after a salty run and wipe with a soft cloth. Avoid harsh solvents or abrasive pads around the trim so the surrounding bezel area stays clean and unmarked.