Perko 1074 LED Utility Light with Snap-On Front Cover, 12V, Flush Mount

Overview

The Perko 1074 is a 12 volt LED utility light with a snap-on front cover for a clean flush-mounted finish on board. It uses a molded polymer housing, a diffusion lens, and a cover that hides the mounting screws after installation, which gives lockers, cabins, consoles, and service areas a finished look without exposed fasteners.

This light measures 2-1/4 inches long by 2-1/4 inches wide and installs in a 1-3/4 inch diameter hole. It is supplied with 7 inch pigtail wire leads and uses #6 screws, making it a practical replacement or new-install light for small spaces where simple 12V lighting is needed.

Key features

• 12 volt LED light for DC electrical systems commonly used on boats.
• Flush-mount installation fits a 1-3/4 inch diameter cutout.
• 2-1/4 inch by 2-1/4 inch face size keeps the light compact for tight cabin, locker, and console areas.
• Snap-on front cover conceals the mounting screws for a cleaner installed appearance.
• Diffusion lens helps spread the light instead of leaving the LED fully exposed.
• Molded polymer construction is available in black or white to match surrounding trim.
• Supplied with 7 inch pigtail wire leads for straightforward 12V connection.

Variants

This Perko LED utility light is offered in two color configurations. The functional layout remains the same across the listed variants, with the visible housing color changing to suit the mounting location and surrounding trim.

Both variants share the same 12V LED format, flush-mount installation, diffusion lens, snap-on front cover, and 2-1/4 inch by 2-1/4 inch face size.

• 1074DP2BLK: Black finish. The black face works well where the light is being installed against dark panels, black console trim, or areas where a lower-contrast look is preferred.
• 1074DP2WHT: White finish. The white face suits light-colored cabin panels, interior liners, and utility spaces where the fixture should blend in with common white marine surfaces.

Installation and fit

The light is made for flush mounting, so the cutout size matters before purchase. Confirm that the mounting surface can accept a 1-3/4 inch diameter hole and that there is enough room behind the panel for the light body and wire leads.

The snap-on front cover goes on after the light is secured, leaving the screws hidden from view. This is helpful in visible cabin or cockpit-adjacent locations where the fixture needs to look tidy after installation.

Use on board

This utility light is a good match for small lighting tasks on 12V boats, including cabin storage areas, helm-side compartments, under-console spaces, cockpit lockers, and service access points. It is best used where a compact flush-mounted light is needed rather than a large area light or navigation fixture.