Overview

The Simrad 000-14074-001 is a mounting bracket kit for the AP48 rotary autopilot control head, letting you bracket-mount the controller where a flush install is not practical. The bracket uses two hand knobs so you can set the viewing angle, then tighten it down for a steady helm layout.

This is a straightforward way to position the AP48 where it is easy to reach and read, whether you are fitting out a new dash panel or updating an older helm that cannot be cut for a flush mount. It also suits installs where the control head needs to sit proud of the surface for easier service access.

Key features

• Bracket-mount kit for Simrad AP48 rotary autopilot control heads
• Also listed for use with Simrad A2004 units
• Two side knobs let you loosen, re-angle, and lock the unit in place without tools
• Helpful when mounting on a flat surface such as a dash, console face, or bulkhead
• A clean option for refits when you want to avoid a large dash cutout

What’s included

• Mounting bracket
• Two adjustment knobs

Installation and setup

Choose a location with clear visibility from your normal steering position and enough clearance to operate the rotary control comfortably. Leave room behind the mounting surface for cable routing and service access, and avoid spots where the back of the unit will be forced hard against wiring bundles.

On boats that see regular pounding or vibration, it helps to use a solid mounting surface and proper backing support so the bracket stays firm over time. After the first few runs, recheck the fasteners and the knob tension to make sure everything stays snug.

Compatibility and fit

This bracket kit is intended for Simrad AP48 installations and is also associated with the A2004 form factor. Match your control head model before ordering, especially if you are replacing older hardware or mixing components between helm stations.

Use on board

This bracket is a good match for helms where space is tight, where the panel cannot be cut for a flush mount, or where you want the control head to sit at an easy-to-read angle for long coastal runs, offshore legs, or frequent docking and autopilot adjustments.

Maintenance and care

Rinse salt residue from the bracket area during washdowns and keep the knobs free of grit so they tighten smoothly. If the unit is in a high-spray helm, a quick wipe-down after use helps keep the mount looking clean and operating smoothly.