Overview

The Garmin 010-12020-00 is a protective cover that slips over compatible Garmin marine instrument displays to keep the screen and bezel covered when the boat is idle.

It is a hard cover that helps keep spray, sun exposure, and everyday scuffs off the face of the instrument while you are at the dock, on a mooring, or trailering between trips.

Fit is specific to the square Garmin instrument format used on GMI 20, GNX 20, GNX 21, GNX Wind, and GHC 20 displays.

Key features

• Hard cover that seats over the face of the instrument while it is not in use
• Fits Garmin GMI 20, GNX 20, GNX 21, GNX Wind, and GHC 20 instrument displays
• Also fits displays supplied in GNX Wireless Sail Pack 43, GNX Wireless Sail Pack 52, and GNX Wireless Wind Pack
• Helps keep salt spray and grime off the screen during dockside storage and washdowns
• Removes quickly before use, with no wiring or changes to the mount

Compatibility and fit

This cover is intended for the compatible Garmin instrument displays listed above and does not fit every Garmin control head. It is not compatible with the GHC 50.

Installation and day-to-day use

Use is simple: slide the cover over the installed instrument until it seats fully. Before putting the cover on, wipe the screen so grit and salt crystals are not trapped against the lens.

Where it makes sense on board

This is a good match for exposed helms, sailboat instrument clusters, and cockpits where instruments sit in the weather between runs. It is also handy for boats that see frequent washdowns or sit uncovered in strong sun at the dock.

Care and storage

Rinse with fresh water after heavy spray and wipe the inside clean before reinstalling. Keeping the cover and screen clean helps prevent fine scratches over time.