Overview

The i2Systems APL-2W-30K-PW11 is a round LED downlight that puts warm white light overhead with a screw-mount, removable-bezel design that suits tight mounting areas on boats.

It draws 2.5 W, throws a 90 degree beam, and keeps the back profile shallow at 1.34 in deep. The visible trim is 3.50 in round with a polished chrome finish that pairs well with stainless hardware and modern interiors.

With stainless steel construction, a titanium-coated trim bezel, and an IP67 rating, it holds up well in wet areas and during washdowns, but it is not meant for submersion.

Key features

• Warm white output (3000K) for cabins, hardtops, and cockpit lighting that stays comfortable on the eyes at night
• 2.5 W draw to keep load low on battery-backed lighting circuits
• 90 degree beam spread that works well for general overhead coverage
• Screw-mount installation with a removable bezel for service access and refits
• 3.50 in round trim with a 1.34 in mounting depth for tighter overhead spaces
• Stainless steel build with a titanium-coated trim bezel and polished chrome finish
• IP67-rated housing for spray and washdowns (not for submersible use)
• Simple 2-wire hookup that can be wired into an existing switched lighting run

Installation and setup

The screw-mount format is helpful where spring clips are awkward or where you want the bezel to come off cleanly for access later. It is a practical fit for hardtops, arches, cockpit liners, and pilot house overheads where mounting depth is limited.

Before drilling, confirm you have clearance behind the surface for the 1.34 in depth plus room for wiring and strain relief. In high-vibration spots, secure wiring so it cannot chafe on fiberglass edges or metal structure.

Electrical and system fit

This light uses a straightforward 2-wire connection and is typically installed on a fused, switched low-voltage lighting circuit. Match polarity, keep connections sealed, and use proper strain relief anywhere the wiring may see moisture, vibration, or movement.

Use on board

Warm white light reads natural in cabins and under hardtops, and the 90 degree beam helps fill a space without the hot spots you get from narrower downlights. Common placements include hardtops, arches, cockpits, pilot houses, and courtesy lighting locations along steps and walkways.

This model makes the most sense when you want a small downlight with a shallow back profile and a polished chrome trim to match surrounding hardware.

Maintenance and care

Rinse salt residue off the trim as part of regular washdowns, and avoid abrasive cleaners that can dull the finish. If mounted in a wet location, check the seal area and wiring connections occasionally to keep water from wicking into the wiring run.