Overview

The Vimar VM08492 is an adaptor that lets you install 1 Vimar 8000 standard module in an Isoset enclosure.

It is a mechanical transition piece, not a switch or outlet by itself. Electrical ratings, circuit type, and wiring method come from the 8000 module you fit into it, which helps when you are matching cabin or helm controls to an existing Isoset surface box.

The adaptor comes in white with a finish similar to RAL 9001, so it blends with common white plates and trim.

Key features

• Made for fitting 1 8000 standard module into an Isoset enclosure
• White finish matched to RAL 9001 (similar) for consistent plate and trim appearance
• Transition adaptor only, the function is defined by the 8000 module installed (switch, push-button, indicator, and similar formats)
• No hinged lid and not lockable, so the final protection level depends on the enclosure and cover plate you use
• Keeps refits straightforward when you want 8000 modules but need the Isoset enclosure format

Compatibility and fit

This adaptor is intended for Vimar 8000 standard modules and Isoset enclosures. It is sized for a single module position, so multi-gang layouts typically use multiple adaptors and a matching faceplate system.

If you are mixing different module families or special-format inserts, confirm the module format before ordering, since the adaptor is specific to the 8000 standard module size.

Installation and setup

Mount the adaptor into the Isoset enclosure first, then install the 8000 module following normal wiring and fixing practice for that device. Finish the job with the correct front plate or cover for your installation location.

On boats, plan the mounting spot so the enclosure stays protected from direct spray and washdowns unless the enclosure and cover system are rated for that exposure, and leave enough service slack to remove the module later for inspection.

Use on board

This adaptor suits owners and installers standardizing on Vimar 8000 controls for cabin lighting, utility circuits, or helm-side switching while keeping an Isoset enclosure already installed on the boat. It also fits cleanly into refit work where you need to change the module style without reworking the back box.