Plash Gravity Surface Mounted LED Deck Light, Warm White Light, White Housing

Overview

The Plash Gravity is a surface mounted LED deck light with a white housing, warm white output, and configuration options for both faceplate style and DC voltage. It is made for low-profile courtesy and accent lighting on boats, with a 3000K warm white color temperature, 105 lumens of output, 1.2W power draw, and a wide 120 degree beam angle.

This light mounts directly to the fiberglass roof or wall of the boat, so the installer does not need to core a large hole for a recessed fixture. The housing is machined aluminum, the light carries an IP67 rating, and the power lead is 9 ft of tinned copper 4-conductor wire with a black insulated jacket, which helps with clean routing during marine installations.

It is available in 12VDC and 24VDC versions. Current draw is rated at 0.2A at 12VDC and 0.1A at 24VDC, making it a practical fit for deck, cockpit, console, hardtop, cabin, and companionway lighting where low power use matters.

Key features

• Warm white 3000K light gives deck and courtesy areas a softer look than cool white lighting.
• 105 lumen output with a 120 degree beam angle helps spread light across nearby walking, seating, or working areas.
• 1.2W power draw keeps battery load low on boats with multiple courtesy or accent lights.
• Available for 12VDC or 24VDC electrical systems, with separate versions for each voltage.
• IP67 rating supports use in exposed marine areas where spray and washdowns are expected.
• Machined aluminum housing surface mounts to fiberglass roofs or walls without coring a recessed fixture hole.
• 9 ft tinned copper 4-conductor wire with black insulated jacket gives the installer useful length for routing to a switch, breaker, or lighting circuit.
• Single 1W OSRAM LED light source keeps the fixture compact while maintaining a focused purpose as deck, accent, or courtesy lighting.

Variants

The range varies by faceplate style and voltage. The available faceplate options are Eyelid, Dome, and Surface Mount, and each style is offered in a 12VDC version and a 24VDC version.

The shared configuration is the white housing and warm white light output. The faceplate changes the finished look of the light at the mounting location, while the voltage selection matches the boat electrical system being used.

Installation and setup

The surface mounted format is useful when adding lighting to a hardtop, cabin side, console area, cockpit liner, or other fiberglass surface where a recessed cutout is not preferred. Run the wire through the mounting location, make the electrical connection, and fasten the fixture to the surface using the appropriate hardware and sealing method for the boat.

Because this is a DC lighting product, voltage must match the selected variant. The 12VDC version belongs on a 12V lighting circuit, and the 24VDC version belongs on a 24V lighting circuit.

Use cases on board

This light is a good match for boat owners, installers, and builders who want small courtesy lighting with a clean surface mount rather than a recessed body. Warm white output works well around seating areas, companionways, cockpit steps, under hardtops, and other places where harsh light is not needed.

The wide beam helps illuminate the nearby area without turning the fixture into a work light or spreader light. It is better suited for visibility, accent lighting, and safer movement around the boat after dark.