Overview

The Perko 0492DP0STS is a pair of stainless steel boat hook holders for securing a pole with an outside diameter up to 1-1/2 inches. Each holder measures 3-1/2 inches long by 1 inch wide, so they take up little space while keeping a boat hook parked where it is easy to reach for docking, mooring, or routine deck work.

This setup is a straightforward way to stow a boat hook along a bulkhead, inside a locker opening, under a gunwale, or in another handy spot where loose gear tends to slide around. The stainless steel construction makes sense for exposed marine areas where spray, washdowns, and normal vibration are part of everyday use.

Key features

• Fits boat hook poles up to 1-1/2 inches outside diameter.
• Sold as a pair so the pole can be supported at two mounting points.
• Stainless steel body suits marine spaces that see moisture and salt exposure.
• Compact 3-1/2 inch by 1 inch size is easy to place where space is limited.
• Uses #6 fasteners, which helps when replacing similar holders or planning a clean install.

Installation and fit

Before ordering, check the outside diameter of your boat hook pole and confirm it does not exceed 1-1/2 inches. It is also worth checking the mounting area for the 3-1/2 inch length and 1 inch width of each holder so the hook can be clipped in and removed without crowding nearby hardware.

These holders use #6 screws. Fasteners are not included, so you can match the screw type and length to the mounting surface on your boat.

Use on board

This pair is a good match for owners who want a fixed place for a boat hook instead of leaving it loose in the cockpit or tucked into a locker where it is slower to grab. It suits day boats, center consoles, cruising boats, and sailboats that need a simple storage point for docking gear.

What's included

• Two stainless steel boat hook holders